This is a cover plate to cover the top front part of the P1P/P1S case where the button hole and SD card are.

I could not find a cover to hide the USB cable for my XTouch screen that runs to the internal USB power source through the button hole.

I did not like the cable in view and it looked out of place so I have created a plate that covers the front part of the case.

Not only does this hide the cable, but I think also completes the look of the top front of the case expecially when using a riser.

I use a 10mm LED riser so the design has been based off this.

There are 3 versions in the Bambu Studio file that should cater for most.

1. 10mm version for LED riser with Xtouch Flip Enclosure mod from Teaching Tech
2. 10mm version for LED riser without XTouch
3. 5.5mm version that is slim enough to fit under the glass plate handle if you're not using a riser.