The parts can snap together, but I secured it all with superglue just to be sure.
The design is made to work with a normal lamp socket like the ones you can get in ikea.
number of parts to print:
Dimensions (approx)
material: PLA transparent for inner sturcture, PLA polar white for leaves
Wanted to experiment with an easier way to bend the leaves and used the "au bain marie" method to prevent overheating. Put a layer of water in a large pan and place a smaller pan inside. Put it on a stove and heat it up. It doesn't need to boil to do it's job.
Place on or two leaves on the bottom of the smaller pan and wait till it gets soft. Use a large set of tweezers or similar to pick up a leaf by its "twig".
Now bend and manipulate it slightly with your fingers, it cools down quickly.
Creality
Ender-3 S1 Pro
No
No
Low quality
20%
Creality
White
E-PLA White
The E-PLA has a slight semi-transparent look.