Top glass riser *V2* (Blank) [P1S and X1C]
Copyright Claim
Top glass riser *V2* (Blank) [P1S and X1C]
Boost
12
29
13
Print Profile(3)
0.16mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
PETG - For Medium Heat Resistance
40 min
1 plate
ABS/ASA - For Maximum Heat Resistance
22 min
1 plate
Boost
12
29
13
0
44
33
Released
Description
Version 2 of my top glass riser. I removed the design to have a blank model for simplicity as other models all have designs.
Cleanest and most simple top glass riser out there (in my opinion). No support necessary, 15% Infill, quick and easy print.
For the P1S, likely also works on the X1C
Comment & Rating (13)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Works as intended and holds AMS too. Scared it will break the glass so I take AMS off.
(Edited)
0
Reply
Great print works as described.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed and works perfekt 😃
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
lässt sich gut Drucken und passt optimal
0
Reply
Very good
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Didn't think that it would work with the AMS on top, so cancelled the print.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld