WW2 America Springfield M1903A4 Sniper rifle 1:35/1:72

The M1903 Springfield, officially the U. S. Rifle, Caliber .30, M1903, is an American five-round magazine-fed, bolt-action service repeating rifle, used primarily during the first half of the 20th century.

The M1903 was first used in combat during the Philippine–American War,[5] and it was officially adopted by the United States as the standard infantry rifle on June 19, 1903, where it saw service in World War I, and was replaced by the faster-firing semi-automatic eight-round M1 Garand starting in 1936. However, the M1903 remained in service as a standard issue infantry rifle during World War II, since the U.S. entered the war without sufficient M1 rifles to arm all troops. It also remained in service as a sniper rifle during World War II, the Korean War, and the Vietnam War. It remains popular as a civilian firearm, historical collector's piece, a competitive shooting rifle, and as a military drill rifle.

The M1903A4 was the U.S. Army's sniper rifle of choice during the Second World War. The M1903A4 was a variation of the M1903A3. The only difference between receivers was that the model and serial number on the receiver were split on M1903A4 to make room for the Redfield scope mount. The Redfield scope mount removed the rear peep sight that was standard on the M1903A3. The scope used on the M1903A4 was a Weaver Model 330 or 330C, which was a 2.75x telescopic sight. The receivers were tested by Remington Arms and those that were deemed best, meaning those closest to design specifications were selected to become M1903A4s. The barrels were also selected specifically to be added to the M1903A4 rifle only if they were within almost exact specifications for the design. The front sight on the barrel was never installed on the A4 barrels, however, the notch for it was still in place.[24] Barrel specifications were, in general, unchanged between the M1903A3 and M1903A4, however, the War Department did start installing barrels with 2 groove rifling instead of 4 groove, despite the lack of clear changes from the 4 groove rifling that was the standard up until 1942.[33]

By some accounts, the M1903A4 was inadequate as a sniper rifle. The M1903A4 was a relatively accurate rifle with an effective range of about 600 yards (550 m). These limitations on long-range targeting were due to the limited field of view present in both the Weaver scopes. From its adoption in 1943 until the end of the war it was used extensively in every theater of operation by both the US Army and the USMC.[34] The Weaver scopes (later standardized as the M73 and M73B1) were not only low-powered in magnification, they were not waterproofed, and frequently fogged over or became waterlogged during humidity changes. In addition, the M81/82 optional scopes also had significant flaws. They most notably had less power (2.2x vs. 2.75x) and, like the other scopes on the M1903A4, had serious issues with the field of view.[24][34][35] The USMC and the US Army would eventually switch to a large 8x scope that spanned the length of the rifle designed by John Unertl.

I have set them to a 1:35/1:72 ratio for easy printing, and the size comes from the data provided by the encyclopedia. You can adjust its size to any place by yourself.

Note: If using the model for 3D printing, model repairs may be needed.