This is an accurate model of a Buck Rogers Starfighter / Thunderfighter from the 80th TV series “Buck Rogers in the 25th century”. Complete with sliding canopys, retractable landing gear and two seats just as shown in the TV series.
Its made for 4″ Action Figures and all parts are easy to print on an 20x20x20 printer.
It also can be used for Star Wars Action Figures from Hasbro.
The final model is 40x30x10cm, print time is about 40-50 hours for all parts, the longest print time is 18-20 hours for the back of the body.
Printing instructions.: (Very easy to print if you follow this suggestions)
Print Front and back body and the engines standing upright on the split face, no supports needed.
Print the two Cockpit parts in the same direction with supports “touching built plate only”
Print the landing gear and the cockpit panel in high quality. The cockpit panel also needs supports. Print the Landing gear without supports laying on the side which has small integrated supports for the hydraulic cylinder. The LG consists of two parts which print in place. Move the sky a little to break it free after printing.
Print the wings laying flat without supports
Credits:
Fine_Engineer
Download 3D models
| File | File size |
|---|---|
Buck+Rogers+Starfighter+Thunderfighter
|
7 MB |