These are specifically sized to fit IKEA's succulent plants, but they should be very easily resized in either a slicer or 3D application.

Modeled procedurally using Houdini, they're inspired by plant roots and poison ivy.

I have modeled three different versions:

• root_pot_vase: The easiest to print. Vase-mode compatible, and will be able to be used as an actual pot.
• root_ornament_thick: A bit harder to print, this is actually an ornament for an existing ceramic/plastic pot. You can place your existing pots inside. You need retraction settings well tuned or a way to get rid of fine stringing to print this one.
• root_ornament_thin: Quite a bit harder print, may be better suited for resin printing. I managed to print it on my MK3S+, but it was quite stringy and not very strong.

You shouldn't need supports on any of them!