Adjustable Graphics Card Support
Copyright Claim
Adjustable Graphics Card Support
Boost
9
21
3
Print Profile(1)
0.2mm layer, 2 walls, 8% infill
Designer
59 min
1 plate
Boost
9
21
3
2
37
11
Released
Description
Here is a simple adjustable GPU anti-sag support with a capture nut to prevent the mount from loosening over time. Minimum height is 70mm with a max height of 103mm, diameter of 21mm.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 8% infill
Threads a little tight, could have been my generic filament settings.
The designer has replied
0
Reply
mine were a touch tight on the initial thread in. loosened up eith a completed thread in and out. I’ll probably tweak the profile and upload a new one when I get a chance.
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld