This is a set of models that, when printed, gives the look of a multi-color die without high filament purge waste. It consists of 2 shells and an interior that needs to be glued together. The inside of the die would be the text color, while the outside shells would be a separate color. There are models for a spin-down D10, D20, and D40, that can be used in games such as MTG. None of these models need supports, but brims on the shells of the D10 and D20 are recommended for adhesion. A few of the models give warnings that they need supports, but it's because of some small overhangs I couldn't get rid of. These should be printed with the points facing upwards and at a low layer height for the best accuracy on the numbers. You will want to print these by object in order to have only one filament change. The models included are the smallest that they should be printed at, as the numbers may become illegible. Printing larger works good, as seen on the D40. If you have any questions on the models or want a request, leave a comment or message me. If I think of anything else I will add it.