SILENCER panthera FX AIRGUNS REDUCTOR NOISE SUPPRESSOR UNF 1/2 FIX DESIGNED TO GAIN 31.6X THE SOUND -15DB!

This product is the result of more than ten prototypes!

ok for the caliber of 0.17 => 0.30

UNF 1/2 fix

it is strictly forbidden to sell or distribute this file beyond your own use under penalty of prosecution

-decompression chamber that encloses the barrel

-cell and baffle not straight allowing to break the frequencies and the harmonics of doppler

-internal groove in the direction of the barrel groove to ensure a smooth flow of internal pressure

-everything has been measured with REW to obtain a bluffing result

++the tests even show a power gain of about 11% ( set @ 67J the power grow @73.8J) .

it was produced for fxairguns UNF 1/2 fix, so look at the diameter on the plan

or make a request for your fixation by mail

the measurements speak for themselves,

it reduces the sound by more than 31x! and yes 15db gain!!!

*all the tests were done at no load at half the power

==> Make sure you send us an email to receive the 3D file to print

quick expedition by email

---------FRANCAIS-------

This product is the result of more than ten prototypes & tests in order to obtain the best compromise

"it is strictly forbidden to sell or distribute this file beyond your own use under penalty of prosecution"

It was made for fxairguns, so take a look at the diameter on the map

or send a request for your custom fixture by mail

-decompression chamber surrounding the barrel

non-rectilinear cell and deflector to break up Doppler frequencies and harmonics

-internal groove in the direction of the barrel groove to ensure even flow of internal pressure.

-Everything was measured with REWaudio to achieve a bluffing result.

it's been produced for fxairguns 1/2-20 UNF fix, so check it out

the measurements speak for themselves,

it reduces sound by more than 30x! and yes 15db of gain!!!!

3D PRINTING PARAMETERS

PLA or PETG the face plate on the bed for print

100% infill in PLA or PETG look the plan to print it