NOTE THAT THIS FILE TAKES A LONG TIME TO SLICE JUST LET IS SLICE AND DO SOMETHING ELSE WHILE IT FINISHES! THERE ARE A LOT OF SMALL MOVEMENTS SO IT TAKES A WHILE FOR IT TO SLICE! I COULD NOT UPLOAD A PRINT PROFILE BECAUSE OF HOW LONG THE SLICE TAKES IT TIMES OUT ON MAKERWORLD SO YOU WILL NEED TO SET THE CORRECT COLOR CHANGES YOURSELF. 

1. MAKE SURE THE COLORS NEEDED ARE SHOWN IN YOUR SLICER
2. SLICE THE MODEL
3. ONCE SLICED YOU CAN GO INTO THE SLIDER ON THE RIGHT SIDE AND MOVE TO THE SPECIFIED LAYER HEIGHTS GIVEN BELOW.
4. ONCE YOU ARE AT THE LAYER HEIGHT OF THE COLOR CHANGE RIGHT CLICK THE SLIDER AND SELECT FILAMENT CHANGE
5. CHOOSE THE COLOR YOU WANT TO SWITCH TO.
6. DO THIS FOR ALL OTHER COLOR CHANGES

Made this for me and my wife! hope you enjoy!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA Overture Matte Light Brown Transmission Distance: 0.6
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 3

Swap Instructions:
Start with Black
At layer #18 (1.52mm) swap to Light Brown
At layer #22 (1.84mm) swap to Yellow
At layer #25 (2.08mm) swap to Jade White for the rest.