This pocket knife is designed for light cutting tasks such as opening letters, cutting tape, paper, twine, paracord and standard thickness cardboard. However, it is not designed for heavy cutting, so please do not use excessive force. I strongly recommend that you always follow safe cutting methods and handle the knife with care.

For printing, I would recommend PLA material. Printing without support. For best results, do not change the original orientation of the elements on the table. After printing, the parts should be lapped to each other. Sandpaper may be needed to remove any occasional bumps and smooth out the slides. Afterwards, I would recommend lubricating the sliding areas of the parts with silicone grease. The button will hold up better if a drop of cyanoacrylate glue is put in during installation.

Please note that I do not recommend storing the knife in pockets, bags, or any other device that requires you to reach for it blindly, in case the blade is unexpectedly exposed. Instead, I suggest storing it on carabiners.

Care must be taken when handling the knife, as there is a significant risk of injury. I provide the design only, and the responsibility for the handling of the product and the blades used lies entirely with you. Therefore, I am not responsible for any property damage or injury.

Remember that the user assumes all risk and responsibility in the use of this pocket knife.