Foot Stop for Longboard or E-Skateboard, Extremely Resistant

This accessory Improves traction, balance and control for Longobardos or E-Skates, Allows Better control on Down Hills. PETG Construction – Made using 3D printing, this accessory is made from a high-quality material designed for long-lasting performance. Low Profile - Sits low on the board for a sleeker look, but still provides plenty of traction. Enhanced Traction - This footstop is designed to provide increased traction and can be positioned to best suit your skating style Consistent Drive - Provides a place to always keep your foot for better grip on the board and higher speeds Easy installation: simply install it in the position of the front truck that best suits you, without the need for additional drilling. Washers are recommended for durability. The innovative design of PET-G is designed to increase traction, balance, control, speed and easier driving. If you are a longboarder, this will improve your grip on the board and make it look more stylish. This stopper helps you have better traction especially downhill, around turns, and even doing tricks by providing extra support and providing a solid base for your foot to maintain control while keeping your eyes up and ahead. You'll never look down at your board to place your feet again. The mounting holes are based on standard longboard tucks so you only need longer bolts, and if desired washers, for additional tightening.

IMPROVED TRACTION - This Footstop is designed to provide greater traction and gives extra surface space than anything else on the market!IMPROVED TRACTION - This Footstop is designed to provide greater traction and gives extra surface space than anything else on the market!
LOW PROFILE - Sits low on the board for a more stylish look, yet still gives plenty of traction for cruising
DURABLE CONSTRUCTION - this accessory is built of a high quality material designed for lasting performance
CONSISTENT RIDING - Provides a place to always keep your foot so that you improve faster
EASY INSTALLATION - Simply install onto your current wheel deck, or if you prefer, custom fit it yourself - Using washers is recommended for added durability

0.4 nozzle
Quality; Layer Height: 0.32 mm
Walls; Wall Line Count 12
Infill; Infill Density: 50%
Material; Pet-G
Flow; 105%

0.6 nozzle
Quality; Layer Height: 0.4 mm
Walls; Wall Line Count 10
Infill; Infill Density: 50%
Material; Pet-G
Flow; 105%