608 Roller Bearing
Copyright Claim
608 Roller Bearing
Boost
79
141
30
Print Profile(1)
0.12mm layer, random seam position
Designer
29 min
1 plate
Boost
79
141
30
4
292
169
Released
Description
Print in place 608 roller bearing with, if I may say so, very low friction for printed part.
O.L.S. Design - Optimal tolerances for Low friction, Stability and almost zero chance of parts sticking. Use grease lubricant for maximum result.
P.S. If you like my work please like, rate or comment. This will help me to continue materializing my ideas in this new world for me. Happy printing!
You can check my other models HERE.
Comment & Rating (30)
All
Boosted
Print Profile
0.12mm layer, random seam position
I downloaded and tested several 608 printed models in maker world, and this is the best design by far. 6 stars!
thank you for your work
GIF
The designer has replied
1
Reply
No, thank you for appreciating my work. :)
(Edited)1
Reply
Boosted
Replying to @Tassesin
I get something called "boost". One for you, and it's not enough with the amount of bearings which I ll print.
(Edited)1
Reply
Replying to @alboayal
Haha! Thank you and happy printing! :)
(Edited)1
Reply
Print Profile
0.12mm layer, random seam position
Definitely the best design I've ever found.
The designer has replied
1
Reply
Much appreciated!
0
Reply
Print Profile
0.12mm layer, random seam position
loose but working
0
Reply
Print Profile
0.12mm layer, random seam position
as good as a 3D printing bearing can get. good job with the tolerances
The designer has replied
1
Reply
Much obliged!
0
Reply
i am impressed with how well all parts are seperated after printing, with no need to break anything free. However, the design has an issue. With using the outer raceway(? english is not my first language) to keep even spacing for the rollers, those rollers can no longer actually roll over that surface. Instead, they now have to glide, which results in higher friction. I am not certain how you could possibly fit a cage into this design, so this may be the best it gets, however it does not really utilize the advantages of a roller bearing.
The designer has replied
1
Reply
Thanks for the comment! After many trials and tests, I think this is the best it gets with 3D printing. Many of the designs rely on friction, not rolling. My observation is that if you apply force on the bearing its start to roll, without force it may slide because the friction is really low. Even in sliding the friction is much lower than "two shell design".
0
Reply
this correct? The 608 refers to the dimensions of the bearing, which are 8 ID x 22 OD x 7 wide mm.
The designer has replied
1
Reply
That's correct.
0
Reply
Boosted
good design
The designer has replied
0
Reply
Appreciated! :)
0
Reply
Print Profile
0.12mm layer, random seam position
great
1
Reply
Print Profile
0.12mm layer, random seam position
printed nicely, difficult to make everything roll, but first time ever seeing one, nice job!
1
Reply
Print Profile
0.12mm layer, random seam position
Funktioniert einwandfrei!
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld