There are 3 different versions to choose from.
This is a 2 part version. The hanger should be attached to the wall with two screws and the container can then be hanged to the wall onto the hanger.
This is a simple version that can be hanged using 3M tape or just put it on a table without tape.
A version that fits IKEA Skadis boards. It has 9 contact points to make it strong as it is a heavy container. This is the only version that will require supports. In the 3MF file i tried to use minimal supports.
I am always open for comments, suggestions, feedback etc.
Happy Printing!