Eames Chair Replica raiser elevation
Copyright Claim
Eames Chair Replica raiser elevation
Boost
0
0
0
Print Profile(0)
No Print Profile yet. Add one to earn points.
+ Add Print Profile
Boost
0
0
0
0
1
0
Released
Description
Our Eames Chair Replica chairs are a bit to low for us, so this is a thing to rais them 2 cm. You will need attionial M6x35 screws to replace the old shorter ones. I do not now if they will also fit the original Eames Chair, but they do fit to the replica ones quite well.
Print Settings
Printer:
Bean
Resolution:
0.05
Infill:
100
Notes:
This also is quite well printable with an standard FDM printer, it does look alot better with the SLA one.
Comment & Rating (0)
All
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld