A blupee from the Legend of Zelda series. The included 3MF is colored for use with one AMS unit. This model uses minimal supports. I have separated the ears from the body for easier printing, in the current configuration the ears print flat on the build plate and then slot into holes in the head. This prints significantly faster than having them attached to the head for printing and reduces the amount of support material needed. This should also make the model easier to hand paint should you decide to do so. You can either leave the ears unglued so they can swivel or glue them in place so they are stationary. I left quite a large gap for tolerance so this should still fit together if printed in materials prone to expanding like silk PLA. The ears are on a separate build plate and STL than the body, but they should print fine on the same plate as well. None of my test prints for this model failed.

Note: per another maker, if you scale this model down, you may need to widen the holes for the ears to slot in! This can be done in Bambu studio via a negative part modifier.

This model would look even better with the right glow filaments!

Also please note, the layer artifact halfway up the head is not part of the model and is from an AMS jam I had to pause the print for an extended period of time to fix. This line is not present on my single color test and should not appear for your print if your filament is loading correctly.