1U Amp Vents With Fans
This is a 1u spacer and ventilation system for my Bryston monoblocks which get a little warm.
They work with any 19" amps, servers or W.H.Y. Full 19" width so rack mount would need mods.
They use 40mm fans powered by a Pi4 or USB adapter. Basic wiring and soldering is required.
The rear spacers are placed wherever, to support the back of the amps.
I printed the vents in 4 pieces to fit my build plate then glued them together with CA glue. Screws would work also.
I glued the fans to the back but you could add screw holes if desired.
PLA Pro
.2 Layer height
No supports
If you like, like.
Be cool, and rock on!