Deer Skull Dice Tower

ThIs Dice tower is on the small end, prints quickly and can run a full set of dice all at once! Also prints great without needing to use MMU

It prints in 3 parts, the base, the skull, and the antlers. Everything prints without supports!
I have also included a 3MF file for the skull.

The black skull in the pictures is the skull variant which is just a little different then the regular one! I dry brushed it really quickly with some white paint and I really loved the result

Please use a brim for the antlers. I also recommend to slow down your small perimeters. In bambu It will be under the speed tab and the setting is called "small perimter thershold" I set mine to 6.5 mm. This will slow down the smaller areas and result in a cleaner print while also reducing the chance of them getting knocked off the plate.

Everything should fit in tightly together, so glue is not needed. If you are having a hard time fitting the antlers into the skull you can carefully use the deburring tool if you have it and shave a bit of the peg, or use sand paper to sand it. The skull should "click" into the base and lay tightly against it, the skull should not fall off the tower even if the tower is turned up side down, if your skull falls off then it wasn't pushed into the base properly.

a quick youtube short on putting everything together ---> https://youtube.com/shorts/cfNhXfs7OWM?feature=shared

This model is for PERSONAL USE ONLY, if you want a commercial license and access to more awesome models you can get it on my patreon

https://www.patreon.com/Layersingreen