This is a remixed model of the "2019 Subaru Crosstrek_40 oz Water Bottle Holder" made by tomecar. The goal of this remix was to reduce overhang angles to a max of 45º and to smooth out the overall geometry and appearance.

Compatibility

I have not had an opportunity to test the compatibility on anything other than a 2019 Crosstrek. The other models listed use the same cup holder mat (92177AG170) leading me to believe that the cup holders they are paired with would have very similar if not identical dimensions and clearance.

Here is a list of compatible models/years/trims that I got off of Subaru's website:

Print Settings

Printer:

X1-Carbon

Rafts:

No

Supports:

No

Resolution:

0.3mm Layer Height / 0.6mm Hardened Steel Nozzle

Infill:

25% Support Cubic

Filament:

Polymaker ASA (Scaled to 100.80% to compensate for ASA shrinkage)

Notes:

Printing this model took less than 2hr @0.30mm layer height. I recommend printing in heat resistant filaments. I personally chose to use ASA due to it's temperature tolerances and UV resistance. I believe PETG would also be sufficient.

I've included the .step file for this model which should hopefully make it easy to adjust any dimensions if needed. The unaltered dimensions of the model are as follows:

Upper half:

• Outer Diameter: 100mm
• Inner Diameter: 95mm
• Height: ~80mm

Lower half:

• Outer Diameter: 75mm
• Inner Diameter: 70mm
• Width of Flat Side: 65mm
• Height: ~60mm

Model overall size: 100mm x 145mm