Welcome to the hellish swamp of mechanical keyboards.

When to change the key caps from your mechanical keyboard, headache is lost key puller! order key puller makes wait for a day? 2 days….

No you can just print as you can simply use it!

Simplified Key cap puller for Mechnical Key people including me!

PLA and PLA plus types of material are good fit for this model

1. Print
2. Push the each leg into side gap of keycap
3. hear the click sound to lock in the bottom corner keycap
4. Pull!

This puller is designed to be slightly thinner than a regular key puller to compensate for the negative effects of 3D printing. 
Even though It cannot be used on keyboards where the gap between keys to key is only 1.5 mm or key. In such cases, please use a metal wired keypad puller.

For this model, remix is not allowed as not usual for my models due to “too simple” design. I feel little bit sorry.

Because of the background below.

• Some of remix work which based on my model or saying inspired by my model actually not remix but just copy especially in case it is simplified models(I tried to do so), and I am fine at all with those case :)b
• OTOH, seriously I am not OK I faced is very offensive PMs from such models….very unhappy…
• Frankly speaking I do not want to be “remix hate” guy making very offensive comments with my simple or poor design which anyone can just design, so this is the question to your remix works. Hope you feel not bad for my point.