弹出便便剑pop up poop sword
Copyright Claim
弹出便便剑pop up poop sword
Boost
61
103
9
GIF
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
7 h
4 plates
Boost
61
103
9
0
59
6
Released
Description
聚会桌游必备小游戏！将海盗改为了发射竹屎~看看谁是那个“幸运儿“呢？
（注意需要胶水和三根任意皮筋，以下是内部发射结构的组装图片，优化了原本的结构，每次发射前转动一下内部的撞针，即可随机发射器的位置）
A must-have small game for party board games! Change the pirates to shoot bamboo shit~See who the lucky one is?
(Note that glue and three arbitrary rubber bands are required. The following is an assembly picture of the internal launch structure, which has been optimized. Before each launch, rotate the internal firing pin to randomly position the launcher.)
Comment & Rating (9)
All
printed perfectly so far but where where belongs this piece to ?
(Edited)
The designer has replied
0
Reply
In this section
0
Reply
Replying to @JieSen
thank you. seems like I have to print one piece again.
no chance that the piece fits into.
0
Reply
Replying to @azm1
It only needs to be glued to the upper circular part, and the cuboid in the middle can pass through smoothly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
managed to glue all together. thank you
The designer has replied
0
Reply
Thank you~
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
love it ! thx ! 👍🏻👍🏻
(Edited)
The designer has replied
0
Reply
Thank you for your love! Fish bones look very cute~
0
Reply
what is the point of this
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld