Spray Can replacement nozzle - WD-40 lubricants
Copyright Claim
Spray Can replacement nozzle - WD-40 lubricants
Boost
332
470
31
Print Profile(7)
0.16mm layer, 6 walls, 15% infill
Designer
36 min
1 plate
bulk print of 4 - 0.2mm layer, 6 walls, 25% infill
Designer
1.5 h
1 plate
0.2mm layer, 6 walls, 25% infill
Designer
29 min
1 plate
bulk print of 6 - 0.2mm layer, 6 walls, 25% infill
Designer
2.2 h
1 plate
Click to see more
Boost
332
470
31
0
613
302
Released
Description
Hey, this is a replacement for spray can straw, you can use it with many spray cans that has 4mm outlet, like WD-40 or other lubricants, also should find for spray can paint. Besides its look cool :) in my subjective opinion of course :) like a gun or tank barrel, shoot your favorite lube all over the place :)
Comment & Rating (31)
All
Cool print! Holes to fit on the can nozzle were a bit small, but nothing some clean up with a drill bit can't fix. I'd also prefer the outlet straw be slightly smaller in diameter, as it comes out in more of a trickle than a shot. Still, it prints nice, looks cool, and is a neat idea.
2
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
Läst sich sehr gut drucken!
0
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
parfait 👍
0
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
Perfect. Thank you sharing.
0
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
it works
0
Reply
Print Profile
0.16mm layer, 6 walls, 15% infill
Hat nicht gepasst
0
Reply
Print Profile
bulk print of 4 - 0.2mm layer, 6 walls, 25% infill
These work better than expected for all my broken cans!
0
Reply
Print Profile
bulk print of 6 - 0.2mm layer, 6 walls, 25% infill
doesn’t quiet fit on a nozzle for wd40
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld