Without a doubt, the single most useful model I have printed over the past couple years, here is a custom cell phone holder that you may find to be useful also. I bought a new pick-up that just did not have a real good convenient spot to carry my cell phone. Enter the 3D printer solution. This holder is built around a cell phone that has an OtterBox protective phone case which makes it wider and longer where other holders would not fit. This one worked so well, I made a 2nd one for the passenger side and my wife loves it. (Mission accomplished).
Will it fit your rig? Don't know. It is designed so that the one “arm” of the model is slid up and in-between the side of the center consol and the carpet, as pictured. It is held in place with the tightness/compression of being wedged between the carpet and the center consol. It's purposely tight and will not damage anything. Look at your car/truck and imagine the placement. It takes up very little space and I have not hit it with my leg or knee and yet is super handy and in reach at all times.