D12 WPL 1:10 Kei Truck TRAILER

New trailer for the fantastic WPL D12 1:10.
The trailer body is a copy of the truck payload bay, dimensions are the same.
Chassis is using one axle fitted on spare D12 1:10 leaf spring pair sold on Aliexpress. This axle receive one bracket each sode on which you can fit 2 spare D12 1:10 wheels you can also find on Aliexpress for almost nothing.
Wheels receive special insert to be able to be fitted with M2 x 20 or 25mm screw.
One M2 x 16mm is needed each side to fit the two wheels brackets.
Do not screw too much to let ir rotate freely.
Leaf springs are fitted with self tapping screw 2mm x 8mm like those on the truck
Some M2x 16mm are required to fit the leaf spring fixtures on the chassis.
Finaly You need some M1.4 x 12mm screws for the leaf spring locking and Some M1,4 x 8mm to fit the eyelet fixture on the chassis.
Re drill eyelet fixture to 4mm , slide in the eyelet and glue at the end the eyelet stop. then the eyelet can rotate freely. Then cut over length.
Trailer body is in two parts, surrounding and base plate to be glued together.
Base plate is screwed on the chassis with same screws then for the leaf spring.

One special axle is also included to use only 2 wheels instead of 4. Just fit it in same position and fit the wheel at each end.

To tow with the truck you have to download as well the truck hook system. https://cults3d.com/en/3d-model/gadget/d12-wpl-1-10-kei-truck-rear-hook-system

As usual you have to redrill holes for screws a bit bigger than screw when going through and a bit smallerwhen needing screw in.

Check carefully all pictures to see the assembly

In case of any question of needed modifications according your own wishes, feel free to send an Email to luc.tellier@wanadoo.fr
I can also cut parts if too big for your machine

Nothing special, 205°C nozzle and 60°C bed.
60mm/s