Hello! These models are Star Wars themed, for the “Dark Side.” Multiple models are linked, two of which have a geometric backing, two of which do not.
Printing:
Printing these models has never resulted in any failures. No supports are needed on the solid backed model, however, supports may be wanted on the geometric backed model.
In order to print the models with 2 colors, add a pause or a color change at 2.4 mm. I used Bambu PLA basic for all filament on these models, with a layer height of 0.1 mm.
Post Processing:
Support removal is fairly straightforward. Use any needle nose pliers, (ensure the “clamps” are open), to gently poke the supports. The pliers should only break through the film connecting the supports together. Once you have broken the film, tightly clamp down on the supports, and pull out.
If you liked these models, please go and check out the other models in this short series, themed towards the “Rebel Alliance,” with an actual geometric backing!