Filament Tube Sleeping Koala
Copyright Claim
Filament Tube Sleeping Koala
Boost
26
17
2
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
Boost
26
17
2
0
18
6
Released
Description
This cute little fellow is designed to attach to the PTFE tube on my A1 Mini for a little bit of whimsey and to bring a smile to my face—no other purpose.
Simply press the 🐨 onto the tube or slide the tube through the hole. He will ride along with all future prints and sleep right through them.
Do you know that koalas can sleep up to 20 hours a day?
A koala photo on our land a few years back inspires this design.
Please be sure to share a photo of the koala in your environment. 🐨
Comment & Rating (2)
All
He is so cute, but mine does not stay. Do I need to do something to keep him from sliding down?
The designer has replied
0
Reply
That's odd - must be a slightly smaller tube. What about putting a small piece of Blu-Tak in between his hands?
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld