ImpulseRC Apex 5" DJI Action 2 Mount

ImpulseRC Apex 5" DJI Action 2 Mount (25 degree tilt)

I do not know who is responsible for the original case design. Message me and I will credit you.

I reverse-engineered some of the original designer's elements and then added some must have features for myself.

Camera Side-Loading - I wanted rear screen protection while also making it easier to swap out the camera. The original rear access is too fiddly with a battery in place.

ND Filter Slot - The original design had the ND filter sitting on top of the camera itself. I added a slot with a separator to protect the camera.

This will fit either TBS 36x33x1.9 (mm) ND filters or the Camera Butter Black Diamond.

I recommend printing this on its side.

UPDATED

There is an additional version that accommodates a 2-piece washer to alleviate 'crushing' the print itself. This will essentially give back the (4) fasteners that are usually not as tight as the others when using action camera mounts. The model has a bit of negative tolerance to hold the sleeve bearings in place also the foot is 0.5mm shorter than the sleeve bearing to 'bite' just enough to keep your camera firmly in place. NOTE this is a 20deg tilt as opposed to the original 25deg

Hardware Required

You will need finish washers and sleeve bearings

https://www.aliexpress.us/item/3256801661029290.html?spm=a2g0o.productlist.main.41.7fba7c69uhAyAh&algo_pvid=80f5af16-5545-4199-8085-a73bd39bfa13&algo_exp_id=80f5af16-5545-4199-8085-a73bd39bfa13-20&pdp_npi=3%40dis%21USD%212.45%212.45%21%21%21%21%21%402102169316846917731048790d075a%2112000017836932283%21sea%21US%210&curPageLogUid=3ugKylFcJuIB

&

https://www.aliexpress.us/item/2255800234019489.html?gatewayAdapt=glo2usa4itemAdapt