Llymlaen's Trident

Dangerous Ladies' 3D models for Llymlaen's trident.
Model by Jennifer Rezny (@quicksparrows)

.stl format. Pre-sliced for printing on a 250mm tall bed, but many pieces will fit shorter. I've also included whole versions if you'd like to cut your own.

Trident finishes at 80" by default. You can adjust this by printing at scale (details below) or cutting the PVC pipe handle shorter.

It assembles on the following hardware:
Handle - 3/4" PVC pipe, cut 49" long
Head - 1/2" dowel, cut 12.6" long
Pommel - 1/2" dowel, cut 10" long

If you want to use a 1" wooden dowel (OD 25.5) instead of a 3/4" PVC pipe (OD 27mm) you can print everything at 94% scale. This will, however, make your head and pommel dowels too large; you can use 7/16" dowels instead, which are hard to find, or 3/8" ones wrapped with paper tape or a LOT of glue to fill in the gap. (You can also omit the smaller dowels entirely, but hey, don't you love durability?

You can also get a smaller trident going by printing everything at scale. For example, if you print the trident at 72%, you can use a 3/4" dowel for the handle instead, getting you a 60" trident. But this is FF14! Bigger is more fun, even if it's unwieldy. :)

Files include:
- Photos
- .STL files

We printed ours at 0.1 and 0.15mm layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1-1.2mm.

Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.

Feel free to tag us to show us what you print and make! We love to see finished works.

http://dangerousladies.storenvy.com
http://twitter.com/dangerousladies
http://instagram.com/thedangerousladies