Retro Space Ork Halftrack with Flak Gun
Retro Space Ork Halftrack with Flak Gun
Published 2024-01-08T13:50:08+00:00
An addition for my wife's retro Speed Freekz army, this is a 28mm compatible interpretation of the old Epic Ork "Flakwagon" built from scratch in Tinkercad.
Included are two different options for the track guards (with / without side armour), three different rams, and a rear deck option if you want to run it as a trukk without the gun.
Designed for FDM printing, test model was printed in PLA at 0.12, 15% infill on a Creality CR6-SE. No supports should be required; smaller parts may need brims depending on how good your adhesion is.
Parts labelled with "x2" etc need to be printed that many times. The kit uses 11 short (15mm) pegs; these are the same as 6mm dowels which may be used instead. Also required are 5 "skinny" 15mm x 4mm pegs. One normal and 2 skinny pegs are used in the gun, so if you're omitting that you can reduce the number of pegs.
Date published | 08/01/2024 |
Support Free | YES |