AIRSOFT MOLLE MOUNT CASE FOR UNIVERSAL PHONE for big Patch

Lockable housing for tactical vest molle cells (JPC, CPC, NCPC and others) for universal phone sizes. The maximum width of the phone is 7.5 cm, the length is 16 cm. The thickness of the phone does not matter, since it is made with a margin. The case is designed for use in airsoft and similar games.

To assemble the case, you will need: a 3D printer, a round rubber band with a diameter of 2-3 mm. (length 25 cm), Velcro panel for the patch and a rubber panel for cushioning the phone (if necessary) - glued from the inside. The total amount of plastic used with supports is 220 grams.

The elastic band must be threaded through the holes so that the corners of the phone are fixed in the case, tighten and tie into a knot. To fix the case in the closed position (vertical position), it is necessary to thread an elastic band through the molle cell and fix it on a knot. A piece of rubber damper, measuring 5 by 6 cm, can be glued to the inside of the case so as not to scratch the back wall of the phone. A Velcro patch panel, measuring 12.5 by 7.5 cm, is glued to the outside of the case. Use super glue to glue the surfaces.

The case is suitable for models with dimensions 7.5 - 16 cm. and iphone models: iPhone 6, 7, 8, 9, 10, 11, 12, 13, 14, 14 Pro, 15, 15 Pro.

Petg: Recommended printing speed is 50 mm/s with a maximum print height of 0.2 mm. The nozzle temperature is 230-235 degrees, the table is 70 degrees. For a better display of the case, place the model face up. In this case, support will be required.