xtouch P1P/P1S Chamber Temp Enclosure
Copyright Claim
xtouch P1P/P1S Chamber Temp Enclosure
Boost
99
158
133
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
0.16mm layer, 2 walls, 15% infill
35 min
1 plate
0.2mm layer, 2 walls, 15% infill PETG PolyLite
35 min
1 plate
Boost
99
158
133
1
782
760
Released
Description
Integrate the DS18b20 temperature sensor into your BambuLab 3D printer's XTouch Controller with ease.
Project link: https://github.com/xperiments-in/xtouch
Buy the DS18b20 used here
Comment & Rating (133)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
au top
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
finally got around to installing the temp sensor, printed really nice. thx
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
tutto perfetto profilo ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in green Bambu Lab PETG Basic, works well, no issues!
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
nice print fit perfectly
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I think modeling has become too tight for me.
I cut the soldering pins on the bottom of the board short, and there was interference with the resistance at both ends, so I ground them down a little with a chisel, and then I was able to fit them into place.
I'll use it well. It's so pretty.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice...
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
druckte problemlos..
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (3)
Click to see more
Related Models
© 2024 MakerWorld