Eagles Christmas Ornament
Boost
5
2
3
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
1.9 h
1 plate
Boost
5
2
3
0
6
1
Released
Description
Philadelphia Eagle wearing a Santa hat ornament. I turned off ironing on the profile that is uploaded because it caused some of the colors to mix. You can change the hat color in the profile. I made the center of the ornament one solid color to cut down on color swaps, it cut the print time and the flush waste in half by doing so.
Comment & Rating (3)
All
scaled it up a bit and had to change the hat color to green since I can only do four colors, but I’m happy with how it turned out mostly. only knock against the print is my fault and that’s that I should have added a couple more top layers to hide the infill.
The designer has replied
1
Reply
Actually like it with the green hat so it sticks with the team colors. Yeah I've had some filaments that cover fine with few top layers but some need to be a little thicker to hide that infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Print turned out great. forgot to take a pic before putting my Christmas stuff away.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld