Minimalist Nintendo Switch Controller Stand
Boost
81
176
38
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
2.4 h
1 plate
Boost
81
176
38
2
303
223
Released
Description
Print at .2-.28 layer height. 10-15% infill. Used Polymaker Black PLA.
Check out my other stuff on Patreon at https://www.patreon.com/PlaGROUND
Comment & Rating (38)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Passt perfekt.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Suits the controller like a glove. Thank you.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fits so perfect. Cannot recommend this print enough.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It fits my Nintendo controller, but the print will require a bunch of sanding to make it look clean.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great looking stand to hold a pro controller
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect fit for the pro controller. It even has slots for the LEDs at the bottom 😂
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It’s a perfect fit for the controller! Looks really stylish and attractive
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
clean model, great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It needs a lot of sanding but it’s a good model overall. print with a lower layer hight for better results.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
didn't fit the controller I have
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld