Resistor Lead Bending Tool
Copyright Claim
Resistor Lead Bending Tool
Boost
22
62
13
Print Profile(1)
PETG 0.2mm layer, 2 walls, 15% infill
14 min
1 plate
Boost
22
62
13
0
86
74
Released
Description
Simple resistor lead bending tool.
Nice tool to have on your keychain :)
Comment & Rating (13)
All
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
perfection
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
What's there to say?
It is what it is, a nice and very simple tool which can do the job.
Also for people who like a fast print so that they can get to start soldering, just fire this one up.
Only takes a maximum of approximately 15 minutes on stock printing speeds, which includes all the usual calibration steps.
Please note: This one was printed in PLA.
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
Nice and simple tool print. I gave some of these away at a ham radio meeting and they were very well received.
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
good working
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
Seems to work well for resistors. I have some diods I need to test but diods have thicker leds so that will be interesting...
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
Klein aber fein. Ein super Helfer zum Wiederstand usw. zu biegen. Klasse.
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld