No Print Profile yet. Add one to earn points.
UPDATE:
Thanks to Sheriandjohn Tompkins for pointing this out, you can use the Y extension mod with the Z brace now!!! ( http://www.thingiverse.com/thing:921948 )
I have made them 8 mm shorter to compensate for the Z brace mod so that when both installed, the extension length stays 120mm.
This is a mod to extend the Y axis of the Wanhao Duplicator i3 120mm. You will need:
-A longer GT2 Belt (24cm longer)
-2 8mm x 500mm steel rods
-6 M3 size screws (any length will do)
-Change the Max Y in EEPROM to 320
-Cut the two tiewraps that hold the plate cables so that the plate can move further down.
A bigger build plate or just longer Glass.
And DONT INSTALL IT LIKE I DID! Do it the right way! :)
Instructions:
Done!
Printer:
Wanhao Duplicator i3
Resolution:
0.2
Infill:
25
Notes:
Infill percentage can be changed according to preference. I had 25 and it works OK.