Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.8 h
1 plate
Boost
42
81
5
0
83
63
Released
Description
Saw ones like this online. Some plants don't like their leaves to get wet, or are hard to get water into the pot.
Normal settings, two options for printing - as one piece (I used tree supports, ironically…or unironically, idk…), or maybe split it in two for easier printing to glue together after, if you need to.
The one pictured printed well as one piece at 0.2mm, Quantum green PLA, tree supports.
Should scale well, .Step file attached.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
printed well in 2 hours, good design.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
very very beautifull
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld