Another Base, you may ask.

Yes, but this is magnetic. ;)

I testet several other counters, but no one fits to my needs, so I created this one. It tool several tests but now they are usuable.

I am using 6x3mm magnets in base and head. So you can quick change the base with additional counters or similar. Pretty easy. I also added a +10 raiser and +20 raiser with magnet.

To get best results print in a small layer heigth. I do in 0.12 with best results.

For simple base without colored numbers i recommend to switch color in Layer 13. Start with black, and then change to white for usual monsters or yellow for epic monsters.

If you want to give the HP riser base a nice look, start also in black and switch to any color you like in layer 12.

The risers have manual support enforcers set to the edges. Its a pretty small amount, but the print is way better than without.

I choosed different colors for different HP raiser amount, to make it easy readable.

• Blue +10
• Green +20
• Red +30

I added a nice black/red Head for Bosses.

The colored bases you can easy colorize with Object Parts. They can only printed with AMS/MMS.

I added three print Profiles:

• Single Color - thats obvious
• Multi Color - Layer Change
  exept the head, all tems starts with black and they are changing on some layer the color. Choose this if you want your bases a bit more fancyer. You can print this with and without AMS. No Prime Tower enabled.
• Multi Color - AMS only
  Obvios again, only AMS works here. All raiser are still changing color at layer 11. The Boss Head and the basic bases are full colored. Prime Tower enebaled, but thats a small amount. Just check your flushing options when changing from black to white and the other colors.

Choose your preferred Profile and set the color you want to use. For Gloomhaven print the base in white and afterwards in yellow again. ;)

Have fun, and let me see your prints and scenarios!

You can watch our Gloomhaven Sessions on my Instagram Account.