Bed Plate Tidy Stand
Copyright Claim
Bed Plate Tidy Stand
Boost
9
6
10
Print Profile(1)
0.24mm layer, 4 walls, 15% infill
Designer
1.5 h
1 plate
Boost
9
6
10
0
37
20
Released
Description
A simple plate stand, quick to print, that just slots under the side of your X1C and assuming P1P/P1S has the same bottom, it'll fit under them also.
No wiggle room so holds very sturdily. Just stand up your spare plates and push the mount towards the printer which secures it in place.
Quick to print and saves room.
Comment & Rating (10)
All
Print Profile
0.24mm layer, 4 walls, 15% infill
Perfect 👍
0
Reply
It's too thick to really fit well under the X1C. The printer can easily slide back and forth with it on top. I thought for sure when I came back it was going to be for the P1P/P1S.
The designer has replied
0
Reply
Hi, I'm not sure why it doesn't fit under your one as it slots perfectly under my X1C. just enough room to move freely in and out but not enough wiggle room to fall over. Do you have different feet on your X1C?
(Edited)0
Reply
i measured the space to be exactly 3.25mm. part i created for it fit basically perfectly. not sure why the differences.
0
Reply
Replying to @Robnob9
No, factory model. Its strange. A few people printed the version I made and have success with it. Maybe a change to the device after they started manufacturing? Something so tiny wouldn't be noticed by many people.
0
Reply
Print Profile
0.24mm layer, 4 walls, 15% infill
Awesome for fitting a bed or two snug against my X1C
0
Reply
Print Profile
0.24mm layer, 4 walls, 15% infill
Other Issues
0
Reply
Print Profile
0.24mm layer, 4 walls, 15% infill
Other Issues:Didn't fit under my x1c, it was too thick.
0
Reply
Print Profile
0.24mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld