Pastamatic Base Plate Remixed by andythilo

Remixed by

andythilo

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Version 2 - 0.2mm layer, 4 walls, 20% infill

Designer

5.3 h

2 plates

4.9(42)

0.2mm layer, 4 walls, 10% infill

Designer

5.4 h

2 plates

4.9(9)

Boost

155

351

433

Released

Description

Designed to securely mount the pastamatic winder. The sides will slide on for a secure fit but I've added 8 x M3 holes on the base so you can add heat-set inserts into the arms. There is also a top hole for hanging up.

p.s excuse the photo quality, my camera is rubbish lol :)

Comment & Rating (73)

@elfring

Print Profile

Version 2 - 0.2mm layer, 4 walls, 20% infill

I like the Pastamatic filament respooler, but it seems rather flimsy in use. I was looking for something to help secure it to the table and keep the sides connected and aligned. This does the trick!!

The designer has replied

@andythilo

Glad you like it, as soon as I printed mine I knew it needed a base, thanks for the rating

@SummersWoodwork

Replying to @andythilo :

how do you make the connection joints? I would like to learn to make them.

@andythilo

I did it manually in fusion 360, just sketched one joint then copied. Never done it before either and it’s very tight but works. it’s not like they need to come apart again.

@dadhacks

Print Profile

0.2mm layer, 4 walls, 10% infill

Works great. Only tweak I would recommend is to adjust the screw hole near the center on the geared side. The original screws into the dovetail piece on the right side frame. I was able to sink a screw about 1/2 inch to the left to fix it.

The designer has replied

@andythilo

Thanks for the feedback, I’ll have a look at it. Got a new wiper design coming which mounts on the bottom.

(Edited)

@christopherd

Replying to @andythilo :

where can we find the wiper?

@andythilo

Hi, I didn’t release it as it would only last a few spools before needing replacing. worked well but the spools cut into it and created a lot of dust.

(Edited)

@Kslade

Print Profile

Version 2 - 0.2mm layer, 4 walls, 20% infill

Adds exactly what the pastamatic needs to be a great respool system Kudos to the designer

The designer has replied

@andythilo

Thank you 🙏

@Ellinas71

Print Profile

Version 2 - 0.2mm layer, 4 walls, 20% infill

Snug fit, keep pressing.

The designer has replied

@andythilo

She’ll fit 😊

@TheEngineer

Print Profile

Version 2 - 0.2mm layer, 4 walls, 20% infill

While the ability to break down for storage has advantages, mounting the re-spooler to a baseplate not only makes the re-spooler easy to use, but also allows hanging on the wall for storage.