Bambu AMS drawer Stand Shared by Exotech

chenwei

Shared by

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 25% infill

43.9 h

6 plates

4.7(21)

Much faster, 17hr vs 44hr 1kg PLA, 0.28mm layer, 2 walls, 15% infill

16.7 h

6 plates

4.6(5)

Boost

145

260

470

642

Released

Description

Original Creator is chenwei

Disable Flow Calibration !

Slowly tap into the interference fit with a wooden hammer. I printed in PLA, not ABS, it warps. I have uploaded my parts and location for your reference. I increased the padding of the handle, 15% is too small. I already broke one, 45% filled reprint. Do not mistake the installation direction, it is difficult to disassemble after installation. Turn off "Flow Calibration" when printing as it will affect the printed part.
If you're going to put it on top of the printer，don't print first, I am designingplaced on the printer, testing and uploading. I originally designed this to sit on a desk. If placed on the printer, it will interfere with the screen and cover handle.

This version is an early design and I recommend printing the version below.

on the printer：

https://www.printables.com/model/465919-put-on-the-printer-bambu-ams-drawer-stand

Comment & Rating (37)

@marcusmxk

Print Profile

0.2mm layer, 2 walls, 25% infill

Prints decently well but the large solid pieces take too much time on a stock 0.2mm profile. I created another profile to use 0.28mm layer height and less infill to make a much faster print

The designer has replied

@Exotech

nice 👍 but why do you give 4 stars?

@dt.pepsi.girl

@marcusmxk Your drawers dont seem to shut flush with the frame in the picture. I tried your version of the print and my drawers do not close all the way flush either. Do you have an updated fix?

(Edited)

@Mymaxdom

Print Profile

0.2mm layer, 2 walls, 25% infill

perfekte Passform. Kein Nacharbeiten notwendig. Vielen Dank dafür

(Edited)

@Mymaxdom

Hi ich hätte da mal eine Frage: Wäre es möglich eine Abdecke zu kreieren, so das man den Drawer Organizer auch anderweitig also ohne AMS nutzen kann ? Mir gefällt das Design so gut das ich das System gerne geschlossen ohne AMS gerne nutzen würde. Da ich leider im Designen bzw. Konstruieren nicht wirklich gut bin, dachte ich ich frage hier mal ob jemand so einen Deckel entwerfen kann. Vielen Dank Grüße Mymaxdom