Mini Rope Organizers
Mini Rope Organizers
Boost
73
114
19
Print Profile(2)
Tray and 3 Dishes
Designer
7.2 h
1 plate
0.2mm layer, 2 walls, 15% infill
7.8 h
2 plates
Boost
73
114
19
0
136
62
Released
Description
Use these mini dishes and tray to organize your office or home. This model uses a chunkier rope then my others. I enjoy the look of the chunkiness and may mix it in on other models going forward.
All of my rope models can be found in collections on MakerWorld and Printables.
Print Settings
No special settings needed.
The filament used in the pictures above:
- Polymaker PolyTerra Lavender PLA
Comment & Rating (19)
All
Print Profile
Tray and 3 Dishes
Printed three of them - a bit upscaled to be used for sugar packs :) It printed really well on the first try.
Thank you for model!
1
Reply
Print Profile
Tray and 3 Dishes
Beautiful!
1
Reply
Print Profile
Tray and 3 Dishes
i modded it to make a bigger and plain tray.
thank you very much
1
Reply
came out ok
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very real looking results, clean print!
0
Reply
Auch hier wieder, einfach nur Bombe
0
Reply
Print Profile
Tray and 3 Dishes
whyyyy grid infill
The designer has replied
0
Reply
I used the standard profile from Bambu Studio. That includes grid infill.
0
Reply
Print Profile
Tray and 3 Dishes
very good
0
Reply
This turned out really good!
0
Reply
Is it possible to make a 2-dish version? Thought of resizing to fit on the mini but smaller trays seem like it'll be too small to store anything meaningful.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld