Extendable and Modular Stackable Drink Dispenser by cgn397

cgn397

Tools>Organizers

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

Standard 12oz US soda can, 0.2mm layer, 3 walls, 25% infill

Designer

20.3 h

7 plates

4.8(13)

Standard 16oz US energy drink can, 0.2mm layer, 3 walls, 25% infill

Designer

24.8 h

7 plates

Boost

141

263

565

Released

Description

Modular drink dispenser designed by Ljhtom (Javier Hernando) https://www.printables.com/model/390092-extendable-and-modular-stackable-drink-dispenser-t

(not my design, simply sharing my profiles for US can sizes)

Adjusted for easy use on Bambu Labs printers, sized for either 12oz (soda) or 16oz (energy drink, beer) standard US cans.

For a single layer, print the top + pins, base layer ends, and Additional Layer Med.

For a single additional layer, print Additional Layer Med and input (top) layer ends.

For any additional layers (3rd layer +) print Additional Layer Med and Middle layer ends.

If you want multiple layers, but separated, use the output single upper layer end (this should also be used as the base layer if no rows are meant to feed into it)

Comment & Rating (14)

@goldiesvinyl

Print Profile

Standard 12oz US soda can, 0.2mm layer, 3 walls, 25% infill

looks great

(Edited)

@veryconfusing

Print Profile

Standard 12oz US soda can, 0.2mm layer, 3 walls, 25% infill

Printed in PETG - added a few drops of super glue to the plastic dowells. Builds perfectly as described and holds lots of cans !

@Shadowpheonix

Print Profile

Standard 12oz US soda can, 0.2mm layer, 3 walls, 25% infill

Excellent print, although including a whole bunch of pins on the first plate is a waste of filament - I assembled a 2 level rack and had 3 pins left over. In my opinion, the "base layer ends" plate should have 8 pins on it (the exact amount needed for a base layer), the "middle layer ends" plate should have 5 pins (the exact amount for a middle layer), etcetera.

@danielmeservy

Print Profile

Standard 12oz US soda can, 0.2mm layer, 3 walls, 25% infill

Only minor adhesion issues with this print profile - Should lower the Aux fan for PLA on X1C

@Yedoggie

Print Profile

Standard 12oz US soda can, 0.2mm layer, 3 walls, 25% infill

Great file. If there was any improvements, I would say the pins are a bit tight between the 2 sided of the module. It was easily trimmed for a snug fit though.

(Edited)