Obi-Wan Kenobi's Lightsaber (Episode III) Remixed by jarvizar

Remixed by

jarvizar

Props & Cosplays>Other Props & Cosplays

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.15mm layer, 2 walls, 15% infill

Designer

6.9 h

4 plates

4.8(27)

Boost

124

261

308

540

Released

Description

3D Model of Obi-Wan Kenobi's Lightsaber Hilt!

Originally created by CaseStudyno8

https://www.thingiverse.com/thing:1839833

I spaced out the pieces onto separate plates by color and modified the original model(s) easier use with Bambu printers, especially sharp overhangs.

Personally I used PLA basic filament for the black pieces, and PLA silk for the silver, gold, and copper (or bronze) pieces.

Collection of other lightsaber hilts: https://makerworld.com/en/u/1935755220/collections/41572

Comment & Rating (33)

@mikeyriot171

Print Profile

0.15mm layer, 2 walls, 15% infill

Awesome print

@michaeljgrosser

Would you mind sharing which gold filament you used for this? it looks great.

(Edited)

@mikeyriot171

Replying to @michaeljgrosser :

Absolutely - It's Bambu PLA Silk - Gold https://uk.store.bambulab.com/products/pla-silk I Also used Bambu PLA Silk Copper and Silver for the other pieces 😊

@michaeljgrosser

Replying to @mikeyriot171 :

Thanks! I thought that might be the case but I haven't tried any of Bambu's filaments yet. Thanks for confirming.

@yeetkid

Print Profile

0.15mm layer, 2 walls, 15% infill

Looks amazing after the assembly! Didn't have the right colors to print but painting shouldn't be too difficult. Great model!

@eivind

Boosted

great print, used white, black and grey pla with gold, silver and copper paint

@eivind

Boosted

for some reason it wont allow me to rate it, but 6/5

@CalvinSmithDev

Print Profile

0.15mm layer, 2 walls, 15% infill

Awesome model and print profile. Well worth getting this one.

@stlredbird

Print Profile

0.15mm layer, 2 walls, 15% infill

printed great assembled great!

@Basi_tcs

Print Profile

0.15mm layer, 2 walls, 15% infill

Excelente!!

@dread.

Print Profile

0.15mm layer, 2 walls, 15% infill

Solid model, printed great! Only issue was my own mistake on the support z distance. The part where the saber would extend had the supports fused, and took a good amount of work to clean it up.

(Edited)

@raum

Print Profile

0.15mm layer, 2 walls, 15% infill

The bronze screw failed on the first print, but that was proabbly my issue, not the profile. Everything else printed like a charm! Completed photos to follow.