Ryobi Tool Holder for HSW HoneyComb Storage Wall
Copyright Claim
Ryobi Tool Holder for HSW HoneyComb Storage Wall
Boost
11
26
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
11
26
6
0
41
26
Released
Description
Ryobi tool holder for the Honeycomb storage wall (HSW). Uses the battery port to mount a Ryobi tool on the HSW.
Tested with a Ryobi heat gun, drill, and light.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
This was a modified version, but printed and works well.
(Edited)Strength Issue:I printed 2 and they lasted about 24hrs and then sheared off at the wall. I had a drill on one and an impact driver on the other.
I ended up splitting the model and mirroring it to create a plug and used that on the battery holder - this gave it enough strength.
If printing this model, it is only for very light tools.
0
Reply
I used this on a drill and an impact driver and it worked great, unfortunately, it lasted 24hrs and it sheared off and they crashed to the ground. May look at a way to strengthen it, but at this stage I would say to only use it for very light tools.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
easy print. fits well
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It was pretty weak unfortunately. I was able to put a small flashlight on it, but would not trust a drill or the like on it. I love the concept, I think if there was another honeycomb connector directly below it would provide that extra weight holding capacity needed.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld