Train Tracks compatible with Brio/Ikea - Crossing with opening gates
Copyright Claim
Train Tracks compatible with Brio/Ikea - Crossing with opening gates
Boost
17
53
18
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Wider by 6mm for train to pass, 0.2mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Two colors, two plates, Hilbert Top Surface, A1 mini
2.8 h
2 plates
A1mini 0.28mm layer, 2 walls, 15% infill
2 h
1 plate
Boost
17
53
18
0
58
49
Released
Description
Train Tracks compatible with Brio/Ikea
Crossing for cars to pass.
You need to print 2x Gate part. And it's press fit. Orientate the spheres to sides and firmly push into holes on top of gate posts, till it clicks in place and rests on small place for gate not to sag forward.
Crossing is 14.5 cm long.
Comment & Rating (18)
All
Great model, thank you for designing it!
The designer has replied
1
Reply
thanks. nice 2 color look.:)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The train occasionally gets stuck on the vertical posts that support the gates, they are very close to the track. Printed flawlessly and the gates clicked in and work perfect with no modifications.
The designer has replied
1
Reply
oh interesting, my kids trains dont get stuck. can you measure the width of that train and post. i might be able to do adjustment in model, minimal to have no issue
0
Reply
Replying to @TerTerro
Thomas the train, and Hape brand.
0
Reply
It mostly affects the Hape battery powered Engibe #1. when my kid plays by hand it’s fine, but the motorized one fetches up. I couldn’t find the Hape (under a couch I’m sure) so I pictured the Thomas. I want to print it again in better colors at some point. Only had white for the first one
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
hervorragend einfach klasse,
The designer has replied
1
Reply
glad you like it
0
Reply
Print Profile
Two colors, two plates, Hilbert Top Surface, A1 mini
Schön wäre, wenn die Schranke 90 Grad aufgehen würde. Sonst super
0
Reply
Print Profile
Two colors, two plates, Hilbert Top Surface, A1 mini
good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Wider by 6mm for train to pass, 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld