Pokemon-Umbreon-Multi Color by Prime Tower

Prime Tower

Toys & Games>Characters

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 4 walls, 50% infill

Designer

24.3 h

1 plate

4.5(37)

0.2mm layer, 2 walls, 10% infill

21.4 h

1 plate

4.8(12)

Boost

180

336

827

348

Released

Description

Umbreon from the Pokemon Game series by Nintendo.

Comment & Rating (71)

@Orselon

Boosted

Add more brim to the supports and model because I suffered a lot of low adhesion to the bed

The designer has replied

@PrimeTower

Looks like this eventually worked out for you :) sorry there were problems.

@Erinlee2012

Print Profile

0.2mm layer, 4 walls, 50% infill

This print feels so bad I can’t even use this thing

The designer has replied

@PrimeTower

I’d like to see the video of how it failed… I’ve not had it fail on me and a lot of other people have had the same success. So I’d like to see how I can improve it.

(Edited)

@PrimeTower

it looks like your Prime Tower came off the plate and caused the failure.

(Edited)

@user_1773996653

Try slowing down your printer manually in speed settings. Also remove the prime tower. This failed on me twice i had to slow it down, make it smaller and remove tower to get this to finally print

(Edited)

@justin.l.tabora

Print Profile

0.2mm layer, 4 walls, 50% infill

repainted some hits but overall came out pretty good.

The designer has replied

@PrimeTower

I’m so glad it came out great !! I know it’s a lot of waste and doesn’t always print perfectly..but that one is AWESOME ! Thanks for sharing.

(Edited)

@yagoselva

Print Profile

0.2mm layer, 2 walls, 15% infill

adhesión problems

(Edited)

The designer has replied

@PrimeTower

Sorry to see you had problems, the support seemed to hold it all together on my tests. Care to show or describe where it went wrong for you?? maybe some support or brim settings need to be updated. THANKS for the feedback.

@SzReality

turned out amazing!!!! 10% infill gyroid , normal speed settings with brim and treee supports on the x1c

@TheGryzz

Print Profile

0.2mm layer, 2 walls, 15% infill

Overall it was a great print profile. I couldn't get it to print without a brim; one leg kept falling over early on. was too afraid of it coming loose 20+ hours in.

The designer has replied

@PrimeTower

THANKS FOR THE FEEDBACK!! I will adjust the profile ASAP ! I didn’t experience this problem and I’m sorry you did. I will be better in the future.

@paullotruglio

Print Profile

0.2mm layer, 2 walls, 15% infill

The designer has replied

@PrimeTower

Somehow I botched the support settings after I tested and uploaded…THANKS for the feedback…I have adjusted the profile. So sorry to have wasted the time and filament on that. I should have been better.