I have created a very simple pen holder with a wall thickness of just 2 mm, but in my opinion that is enough. It is possible to deform it by pushing and pulling it with your hands.
The holder has different motifs, one or two at the front and one or two at the back.
I have created different variants.
Variant 1: Triangles with nature
Variant 2: animals
Variant 3: geometric patterns
Variant 4: floral feminine
take a look at them all and decide which one you like best.
Hope you like them
Print settings:
Each holder has the same print settings
First layer: 0,2mm
Layer height: 0,2mm
Infill: 20 % Gyroid
Wall lines: 4
Enjoy Printing
E