Bat Wing Earrings with Tulle by PenolopyBulnick

PenolopyBulnick

Fashion>Earrings

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 100% infill

Designer

16 min

1 plate

4.4(8)

A1-0.2mm layer, 2 walls, 100% infill

15 min

1 plate

5.0(1)

0.2mm layer, 2 walls, Used two layers of rectalinear infill to create the Thule effect

21 min

1 plate

5.0(1)

Boost

130

Released

Description

These simple bat wing earrings are meant to be printed with tulle fabric added halfway through the print. I actually think 4 pieces of tulle added in looks best. You can see that in the third and last picture where there are two wings with 1 tulle piece and two wings with 4 tulle pieces.

You have to trim all the tulle off the edges after, it can be tedious.

Once printed and trimmed, attach to chains and earrings.

You can iron the top layer, but I don't think you have to unless you were to print these in a lighter color.

[Also looks good printed in gold with tan tulle.]

Comment & Rating (13)

@3dHuman

I found the thule a bit clumsy, so I printed the "thule" instead. I added my profile in case you're interested.

The designer has replied

@PenolopyBulnick

That was clever! I think they look fantastic :D

@3dHuman

Replying to @PenolopyBulnick :

…and you can print them multi colour too

@scioli700

Print Profile

0.2mm layer, 2 walls, Used two layers of rectalinear infill to create the Thule effect

Great! Love the tulle infill effect as well as the original profile where you can add your own tulle fabric. Cute design overall too.

(Edited)

@SlowpoksWorksho

Print Profile

0.2mm layer, 2 walls, 100% infill

everything printed good

@SmileyPrinter

Print Profile

0.2mm layer, 2 walls, 100% infill

tried to use a lighter to clean up the edges/extra tulle, I used 4 pieces of tulle which I think may have been a little thick so I'll do less next time