1.需要一只小米温湿度计2，以及8枚10x1mm磁铁；

2.模型分为主体以及底部，壁厚很薄，建议100%填充；

3.打印完成后，需要用胶水进行底部和主体的粘接，需要在主体上粘贴4枚磁铁，将另外4枚磁铁粘在盒子内部，注意磁极；

4.通过小米温湿度计2位置进行干燥器存取。

1.In need of a Xiaomi Hygrometer 2, along with 8 pieces of 10x1mm magnets;

2.The model is divided into a main body and a bottom part, with a very thin wall; 100% infill is recommended;

3.After printing is complete, adhesive should be used to join the bottom and main body. Four magnets should be attached to the main body, while the other four magnets should be affixed inside the box, paying attention to the polarity;

4.Access to the dehumidifier is achieved through the position designated for the Xiaomi Temperature and Humidity Sensor 2.