No Print Profile yet. Add one to earn points.
Hi, here is a jig to make an MFT table top, using a piece of pegboard for accuracy. The best is to have a pegboard that cover the entire surface of your bench in one time
It's designed for 3/4 in holes and 4 in spacing.
Material needed :
3/4 inch router bitJust place and secure (clamp) the pegboard and use the jig to make holes with the router. Move 4 holes each time (pegboard holes are 1 in spaced).
The jig has 3 holes around to help positionning and avoid errors.
It's a little tight to ensure most accuracy as possible, however after some use it's less tight.
Also provide 2 bench dog to help positionninge the pegboard, the 'half pin' are to set fron the side (4 in), the 'full pin' are used if the pegboard is smaller than the table and you need to move it. You can add 14-20 x 1 1/4 bolt in the 'full pin' to make it stronger if needed.
And because we are fancy, I made a MM version, but you can print single material !
enjoy!
Category: Machine Tools